| Model |
CLM-30S |
| pay off width |
300 mm Max. |
| Unwind dia |
400 mm Max. |
| Rewind dia |
400 mm. |
| Substrates to be coated |
Polyester film, stamping foil, Paper etc. |
| Thickness of substrate |
16 - 150 micron. |
| Speed (depend upon material &Coating) |
*30-40m/min (Hot melt Coating)
*8-10m/min (Water Base)
*10-20 m/Min (Solvent Base)
|
| Heating roll |
1 No. |
| Heating Roll Heater |
1 No./ 3 Kw. |
| Tray Heater |
1 No./5 Kw. |
| Chamber Heaters |
1 Kw x 09 N0s. |
| Air Blower |
2 Nos. |
| Air Blower Motor |
0.5 hp x 2 nos. |
| Unwind Core Internal Core Dia. |
76 mm. |
| Rewind Core Internal Dia. |
76 mm. |
| Ac Drive (3-phase) |
2 Hp /1.5kW (1 nos). |
| Ac Motor (Geared Motor) (3-Phase) |
2 Hp / 1.5kW (1 nos) |
| Unwind tension |
Manually by using Pneumatic Brake (Make MMT). |
| Rewind tension |
Manually by using Pneumatic Clutch (Make MMT). |
| Free Margin Control |
By Using Electronic Edge Guiding (Make E+L) |
| Length Counting System |
Digital Pre-set Counter Auto-Cut Length Counting system. |
| Material Loading System |
Material Loading System |
| Control System |
User friendly HMI (Touch Panel with PLC control). |
| Air Required |
6-10 Bars. |
| Power requirement |
15 kW 415V Ac /3 Phase (Max. Machine Running Load.) |
| Coating Possibilities |
Water Base, Solvent Base, Heat Seal etc. |
